VDA6.3过程审核标准是通过对相应过程要素的提问表展开的。提问表提出了至少11条FMEA的相关要求。满足这些要求将会提高组织满足顾客要求的能力,赢得顾客满意,同时减少顾客以及过程审核中关于FMEA中的不符合项。 “P3.3 是否详细策划了产品和过程开发的活动?”要求在产品和过程开发策划时,要包括DFMEA和PFMEA的策划。此项要...
PFMEA exlstJng d咽地nor a m a actions prior1。 pro饵盹 脾刷旧f阳 | 阳础C阳、 酬cepc 碍 阳 PFMEA 。pbmizatÞonol both ü幡 I well 国曲,剑。甜 M P侨民PIPPA produGta耐pr_目 出叼ns Figure 1.5-1 FMEA Timing A ligned w ith APQP Phases 10 应根据项目计划实施FMEA,并根据分析...
Thread hole defects“of drilling process,just defined Angle bad in bending process, Pretreatment factor was not considered in galvanizing process. PFMEA失效模式不准确和不充分,如钻孔过程中的“螺纹孔缺陷”,只定义了弯曲过程中的“角度差”,预处理的因素并不在镀锌过程中考虑。 6 In the PFMEA corrective ...
The AIAG VDA manual goes into more detail than the previous standard in describing the various circumstances upon which a DFMEA or PFMEA review may be required. The manual indicates that the review can be initiated by design changes, process changes, product recalls, quality issues, non-compliance...