首先确认NTP SERVER地址,开启icmp服务。登陆网络设备,在要同步的网络设备上ping通ntp server。ping成功后安如下命令键入: enable 进入特权模式config terminal 进入配置模式ntp server x.x.x.x 指定ntpserver地址clock timezone CST +8 配置时区ntp source Vl 5、an xx 配置ntp所取的网段属于vlan xx(如果无法看...
2. 从服务器索引(优先级)(Server Index (Priority))下拉列表中选择一个服务器的优先级 (server priority). 3. 在 Server IP Address 文本框中输入 NTP 服务器的 IP 地址. 4. 选择 NTP Server Authentication 复选框,启用 NTP 服务器的身份验证. 5. 点击 Apply 按钮. 6. 选择 Controller > NTP > Keys...
首先确认NTP SERVER地址,开启icmp服务。 登陆网络设备,在要同步的网络设备上ping通ntp server。 ping成功后安如下命令键入: enable进入特权模式 config terminal进入配置模式 ntp server x.x.x.x指定ntpserver地址 clock timezone CST +8配置时区 ntp source Vlan xx配置ntp所取的网段属于vlan xx(如果无法看出来属于...
however if you'd like to adjust your NTP server to be running in your local timezone, all you need to do is provide aTZenvironment variable following the standard TZ data format. As an example, usingdocker-compose.yaml, that would look like this if you were located in Vancouver, Canada:...
Thefudgecommand is used to provide additional information for individual clock drivers and normally follows immediately after theservercommand. Theaddressargument specifies the clock address. Therefidandstratumoptions control can be used to override the defaults for the device. There are two optional devi...
o DHCP server Disabled (=off and NOT set as Forwarder!) o Local IP address in subnet of primary router but outside DHCP scope, make sure the used IP address is unique on your network you cannot have duplicates. o Gateway and Local DNS pointing to primary router ...
however if you'd like to adjust your NTP server to be running in your local timezone, all you need to do is provide aTZenvironment variable following the standard TZ data format. As an example, usingdocker-compose.yaml, that would look like this if you were located in Vancouver, Canada:...
puts [response,address] s.close end def get_ntp_time(srv_addr) puts Net::NTP.get(srv_addr).time end if ARGV.count == 1 get_ntp_time(ARGV[0]) else get_ntp_time_udp(ARGV[0],ARGV[1]) end 运行要带2个参数,第二个参数是要发送的报文:./ut.rb time.nist.gov hi , 但是运行后长时...
~server2 0.0.0.0 16 54 64 0 0.0 0.00 16000. * master (synced), # master (unsynced), + selected, - candidate, ~ configured client# ntp source Loopback0 ntp peer server1 ntp peer server2 here is the server config: server1#sho ntp ass address ref clock st when poll reach delay offs...
Support SERVER and BROADCAST working mode; Ethernet port supports 10/100M, full-duplex, half-duplex, supports auto-negotiation mechanism Support user-defined MAC address .NMEA0183 transmits via TCP protocol Compact and easy to install Power consumption is only 1W ...