additionally it appeared to remove klipper.service. moonraker was still running but not doing much. had a backup so deleted my /home/pi/* and started a fresh kiauh and will try another install without my own config. note your config examples do not appear to cover ender 5 pro 4.2.2 boa...
A new Z-Tilt macro in the examples Improvements of the documentation for installation, configuration and switch_offset v0.8.0(2021-08-09) New configurations for executing G-Code commands (useful for V1 users) Bugfix for configuring the z_calibration too early (many thanks to Frix-x), ...
In addition to common g-code commands, Klipper supports a few extended commands - “status” and “restart” are examples of these commands. Use the “help” command to get a list of other extended commands. After Klipper reports that the printer is ready go on to the config check document...
I have the Duet WiFi and Duex5 boards. I've installed Klipper and everything works except the bl touch. The bl touch does its system check moving up and down and I have a solid red light. The debug pin down command doesn't move the pin down. Pushing the pin up or down the probe...
Welcome to the Klipper project! https://www.klipper3d.org/ Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See thefeatures documentfor more information on why you should use Klipper. ...
What you can do is add the config examples for the various boards with the pins exposed to the documentation exactly as it is done for the mcu. ( Kevin allowing volunteers to be accepted;) ) ... I don't have any /dev/gpiochip* device in armbian like in raspios, maybe somthing in...
The pru_rpmsg directory contains code from: https://github.com/dinuxbg/pru-gcc-examples revision 425a42d82006cf0aa24be27b483d2f6a41607489. The code is taken from the repo's hc-sr04-range-sensor directory. It has been modified so that the IEP definitions compile correctly. See pru_rpmsg....
To install the macros, first clone this repository inside of your printer_data/config directory with the following command. git clone https://github.com/jschuh/klipper-macros.git Then paste the below sections into your printer.cfg to get started. Or even better, paste all of it into a se...
It's worth noting, and a very useful feature, that all the essential configuration and tuning parameters (inmmu_parameters.cfg) can be modified at runtime without restarting Klipper. Use theMMU_TEST_CONFIGcommand to do this. Running without any parameters will display the current values. This ...
Klipper + Fluidd in Docker as per prind Config for the XTLW Climber8 (an entry-level IDEX printer). Most of this will apply to any IDEX, and include goodies like a better IDEX display (supporting multiple heads, multiple fans, etc.) Designed for Cura....